[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P0780*00SHIFT ERROR
(Shift Error)
1Diagnosis conditionIgnition switch: ON
Signal
ThresholdWhen any of the following conditions are satisfied if the actuator is not energized:
  • Change of energization register: 5 times or more
  • Abnormal initial drive energization pattern: 21 times or more
Diagnosis delay time
2Diagnosis conditionIgnition switch: ON
Signal
ThresholdTarget range and current range do not match
Diagnosis delay time5 seconds
*: This code is displayed as P0914 on GST.
 
 
POSSIBLE CAUSE
  • Shift actuator
  • Electric shift control module
 
 
FAIL-SAFE
 
 
Malfunction 1
  • Shifting operation is prohibited
  • Powertrain becomes neutral
 
 
Malfunction 2
  • No impact to vehicle behavior
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Depress the brake pedal.
  3. Shift the selector lever to “R” position and wait for 10 seconds.
  4. Shift the selector lever to “Nd” position and wait for 10 seconds.
  5. Shift the selector lever to “D/M” position and wait for 10 seconds.
  6. Press the P position switch and wait for 5 seconds.
  7. Check DTC.
Is DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END