[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P072A00STUCK IN NEUTRAL
(Stuck in Neutral)
Diagnosis conditionWhen the ignition switch is ON
Signal
ThresholdThe shift actuator cannot turn the manual shaft.
Diagnosis delay time
 
 
POSSIBLE CAUSE
Transaxle assembly (Sticking of manual shaft)
 
 
FAIL-SAFE
  • Shifting operation is prohibited
  • Powertrain becomes neutral
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.CHECK CVT FLUID TEMPERATURE
With M.U.T.-III SE
  1. The ignition switch is ON.
  2. Select “Data List” in “TRANSMISSION” using M.U.T.-III SE.
  3. Select “FLUID TEMP” and check that the CVT fluid temperature is 15°C (59°F) or more.
Is “FLUID TEMP” more than 15°C (59°F)
.
  1. Start the engine and warm up the CVT fluid.
  2. .
 
3.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Depress the brake pedal.
  3. Shift the selector lever to “D/M” position and wait for 10 seconds.
  4. Press the P position switch and wait for 10 seconds.
  5. Check DTC.
Is “P072A-00 detected?
Go to DTC Diagnosis ProcedureDiagnosis Procedure.
-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END