[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P060C*00CONTROL MODULE
(Internal Control Module Main Processor Performance)
Diagnosis conditionWhen the Ignition switch is ON
Signal
ThresholdA malfunction is detected in the electric shift control module.
Diagnosis delay time
*: This code is displayed as P0914 on GST.
 
 
POSSIBLE CAUSE
Electric shift control module
 
 
FAIL-SAFE
  • Powertrain becomes neutral
  • Automatic P position system is disabled
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON and wait for 2 seconds or more.
  2. The ignition switch is OFF and wait for 2 minutes or more.
  3. The ignition switch is ON and wait for 2 seconds or more.
  4. Repeat step 2 and 3, three times.
  5. Check DTC.
Is “P060C-00 detected?
Go to DTC Diagnosis ProcedureDTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END