[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P281400SELECT SOLENOID
(Select solenoid)
Diagnosis conditionTCM power supply voltage: 11 V or more
Signal
ThresholdTCM judges that solenoid valve circuit is shorted to ground
Diagnosis delay time1 second
 
 
POSSIBLE CAUSE
  • Harness or connector (Select solenoid valve circuit shorted to ground)
  • Select solenoid valve
 
 
FAIL-SAFE
Selector shock is large
 
 
DTC CONFIRMATION PROCEDURE
cautionBe careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch is OFF and wait for at least 10 seconds, then perform the next test.
: .
 
2.CHECK DTC DETECTION
  1. Start the engine.
  2. Maintain the following conditions. (Keep 5 seconds or more after the shifting.)
    Shift position: N → D, N → R, P → R
  3. Check the first trip DTC.
Is “P2814–00” detected?
Go to Diagnosis ProcedureDTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END