[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P281300SELECT SOLENOID
(Select solenoid)
1Diagnosis conditionWhen all of the following conditions are satisfied:
  • DTC other than the applicable DTC is not detected.
  • Throttle position: More than 6.27 deg.
  • Vehicle speed: Less than 3 km/h (1 MPH)
  • CVT fluid temperature: More than 20°C (68°F)
  • Shift position: Other than P, N
  • Turbine speed when performed N → D, N (P) → R: More than 500 rpm
  • TCM power supply voltage: More than 11 V
Signal
ThresholdWhen all the following conditions are established three times in 1DC:
  • Input speed: 200 rpm or less.
  • Detection time after select position
    • N → D: Less than 0.4 seconds
    • N → R: Less than 0.3 seconds
    • P → R: Less than 0.3 seconds
Diagnosis delay time
2Diagnosis conditionWhen all of the following conditions are satisfied:
  • Shift position: Other than P, N
  • Vehicle speed: Less than 3 km/h (1 MPH)
  • Differences between primary pulley speed and secondary speed: Less than 120 rpm
  • DTC other than the applicable DTC is not detected.
  • TCM power supply voltage: More than 11 V
Signal
ThresholdWhen all of the following conditions are satisfied:
  • Clutch instructions pressure: 0.95 MPa or more
  • Differences between turbine speed and input speed: Less than 200 rpm
  • Turbine speed – speed: More than 450 rpm
Diagnosis delay timeThe counting of time continues while diagnosis conditions are satisfied and stops when the conditions become unsatisfied (the count is maintained). When accumulated time reaches 30 seconds (Clutch is judged as engaged and the count is reset.)
DC stands for “DRIVING CYCLE” and indicates a series of driving cycle of “Ignition switch OFF → ON → driving → OFF”.
 
 
POSSIBLE CAUSE
Select solenoid valve
 
 
FAIL-SAFE
  • When a malfunction occurs on the low oil pressure side
    • Selector shock is large
    • Start is slow
    • Acceleration is slow
    • Vehicle speed is not increased
  • When a malfunction occurs on the high oil pressure side
    • Selector shock is large
 
 
DTC CONFIRMATION PROCEDURE
cautionBe careful of the driving speed.
1.CHECK DTC PRIORITY
When DTC P2813–00 is displayed together with P17F0–07, diagnose first the P17F0–07.
Is "P17F0–07" detected?
Perform diagnosis of P17F0–07. Refer to Diagnosis ProcedureDTC Diagnosis Procedure.
GO TO 2Work Flow.
 
2.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch is OFF and wait for at least 10 seconds, then perform the next test.
: .
 
3.CHECK DTC DETECTION 1
  1. Start the engine.
  2. Maintain the following conditions. (Keep 30 seconds or more after the shifting.)
    Shift position: N→ D, N → R, P→ R
  3. Check the first trip DTC.
Is “P2813–00”detected?
Go to Diagnosis ProcedureDTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END