DTC | M.U.T.-III SE screen terms (Trouble diagnosis content) | DTC detection condition |
P2766 | 00 | INPUT SPEED SENSOR B (Input/Turbine Speed Sensor B Circuit Range/Performance) | Diagnosis condition | When all of the following conditions are satisfied:- TCM power supply voltage: More than 11 V
- After range change completion, it spends 2 seconds or more.
- Range: D
- Engine speed: 450 rpm or more
- Primary pulley speed: 300 rpm or more
- Secondary pulley speed: 300 rpm or more
- Input speed: 300 rpm or more
- Lock-up command is being given (except for slip lock-up)
- DTC other than the applicable DTC is not detected.
|
Signal | Output speed sensor signal |
Threshold | When all of the following conditions are satisfied:- The difference between engine speed and primary pulley speed is 1,000 rpm or less
- The difference between engine speed and input speed is 1,000 rpm or less
- The difference between primary pulley speed and input speed is 1,000 rpm or less
- When any of following items are satisfied:
- Primary pulley speed/secondary pulley speed: More than 2.9
- Primary pulley speed/secondary pulley speed: Less than 0.3
|
Diagnosis delay time | 5 seconds |