[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P086300CONTROL UNIT (CAN)
(TCM Communication Circuit)
Diagnosis conditionEngine is started
Signal
ThresholdAn error is detected at the initial CAN diagnosis of TCM
Diagnosis delay timeWithin 1 second
 
 
POSSIBLE CAUSE
TCM
 
 
FAIL-SAFE
  • Selector shock is large
  • Start is slow
  • Acceleration is slow
  • Lock-up is not performed
 
 
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch is OFF and wait for at least 10 seconds, then perform the next test.
: .
 
2.CHECK DTC DETECTION
  1. Start the engine.
  2. Check the DTC.
Is “P0863–00” detected?
Go to Diagnosis ProcedureDTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END