DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P0792	00	INTERMEDIATE SPEED SENSOR A (Intermediate Speed Sensor A Circuit Range/Performance)	Diagnosis condition	When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V After range change completion, it spends 2 seconds or more. Range: D Engine speed: 450 rpm or more Input peed: 300 rpm or more Primary pulley speed: 300 rpm or more Secondary pulley seed: 300 rpm or more Lock-up command is being given (except for slip lock-up) DTC other than the applicable DTC is not detected.
			Signal	Primary speed sensor signal
			Threshold	When all of the following conditions are satisfied: Differences between engine speed and primary pulley speed: More than 1,000 rpm Differences between primary pulley speed and input speed: More than 1,000 rpm Differences between engine speed and input speed: 1,000 rpm or less
			Diagnosis delay time	5 seconds

POSSIBLE CAUSE

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

caution

Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch is OFF and wait for at least 10 seconds, then perform the next test.

2.CHECK DTC DETECTION

Start the engine.
Drive the vehicle.
Maintain the following conditions for 10 seconds or more.
Shift position : “D” POSITION
Engine speed : 1,200 rpm or more
Vehicle speed : 40 km/h (25 MPH) or more
Stop the vehicle.
Check the first trip DTC.

Is “P0792–00” detected?

Go to Diagnosis ProcedureDTC Diagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END