[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P078000Shift error
(Shift Error)
1Diagnosis conditionIgnition switch: ON
Signal-
ThresholdTarget range and actual range (range of transmission range switch) do not match.
Diagnosis delay time1.3 seconds
2Diagnosis conditionIgnition switch: ON
Signal-
ThresholdTarget range and redundant range do not match
Diagnosis delay time0.38 seconds
3Diagnosis conditionIgnition switch: ON
Signal-
ThresholdActual range (range of transmission range switch) and redundant range do not match
Diagnosis delay time0.38 seconds
 
 
POSSIBLE CAUSE
Shift actuator
 
 
FAIL-SAFE
 
 
Malfunction 1
  • Shifting operation is prohibited
  • Shift position indicator on combination meter is not displayed
  • Powertrain becomes neutral
 
 
Malfunction 2
  • No impact to vehicle behavior
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Depress the brake pedal.
  3. Shift the selector lever to “R” position and wait for 5 seconds.
  4. Shift the selector lever to “Nd” position and wait for 5 seconds.
  5. Shift the selector lever to “D/M” position and wait for 10 seconds.
  6. Press the P position switch and wait for 10 seconds.
  7. Check DTC.
Is DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END