[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P074600PC SOLENOID A
(Pressure Control Solenoid A Performance/Stuck Off)
1Diagnosis conditionWhen all of the following conditions are satisfied:
  • Engine speed: More than 600 rpm
  • Primary pulley speed: More than 450 rpm
  • Idle is not being detected.
  • Acceleration/deceleration speed: −0.49 m/s2 (−0.05 G) or more
  • The primary pulley speed experienced 300 rpm or more and the secondary pulley speed experienced 250 rpm or more at least once.
  • Secondary pulley speed: More than 150 rpm
  • TCM power supply voltage: More than 11 V
Signal
ThresholdThe following condition is detected twice or more (1 second or more later after detection of the first) in the same DC
  • Status with the shifting ratio of the primary pulley speed/secondary pulley ratio exceeding 2.825 is 0.2 sec or more continuously
Diagnosis delay time
2Diagnosis conditionWhen all of the following conditions are satisfied:
  • Engine speed: More than 600 rpm
  • Primary pulley speed: More than 450 rpm
  • Idle is not being detected.
  • Acceleration/deceleration speed: −0.49 m/s2 (−0.05 G) or more
  • The primary pulley speed experienced 300 rpm or more and the secondary pulley speed experienced 250 rpm or more at least once.
  • Secondary pulley speed: More than 150 rpm
  • TCM power supply voltage: More than 11 V
Signal
ThresholdThe following condition is detected twice or more (1 second or more later after detection of the first) in the same DC
  • Status with the shifting ratio of the primary pulley speed/secondary pulley ratio exceeding 3.625 is 0.1 sec or more continuously.
Diagnosis delay time
noteDC stands for "DRIVING CYCLE" and indicates a series of driving cycle of "Ignition switch OFF → ON → driving → OFF".
 
 
POSSIBLE CAUSE
  • Line pressure solenoid valve
  • Control valve assembly
 
 
FAIL-SAFE
  • Selector shock is large
  • Start is slow
  • Acceleration is slow
  • Lock-up is not performed
 
 
DTC CONFIRMATION PROCEDURE
cautionBe careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition switch is OFF and wait for at least 10 seconds, then perform the next test.
: .
 
2.CHECK DTC DETECTION
  1. Start the engine.
  2. Drive the vehicle.
  3. Maintain the following conditions for 10 seconds or more.
    Shift position: “D” position
    Accelerator pedal position: 0.5/8 or more
    Vehicle speed: 40 km/h (25 MPH) or more
  4. Stop the vehicle.
  5. Check the first trip DTC.
Is “P0746–00”detected?
Go to Diagnosis ProcedureDTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END