[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P060B00CONTROL MODULE
(Internal Control Module A/D Processing Performance)
Diagnosis conditionIgnition switch: ON
Signal-
ThresholdWhen an analog-to-digital conversion error is detected.
Diagnosis delay time10 ms
 
 
POSSIBLE CAUSE
TCM
 
 
FAIL-SAFE
  • Selector shock is large
  • Start is slow
  • Acceleration is slow
  • Lock-up is not performed
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON.
  2. Check DTC.
Is DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END