[Previous][Next]
Diagnosis Procedure
1.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SELECTOR
  1. The ignition switch is OFF.
  2. Disconnect the electric shift selector connector.
  3. Disconnect the electric shift control module connector.
  4. Check the resistance between the electric shift control module harness connector terminal and the electric shift selector harness connector terminal.
    P position switchElectric shift control moduleElectric shift selectorResistance
    (Approx.)
    ConnectorTerminalConnectorTerminal
    Switch 1E13146M261 Ω or less
    Switch 24718
Is the inspection results normal?
.
Repair or replace damaged parts.
 
2.REPLACE ELECTRIC SHIFT SELECTOR
  1. Replace the electric shift selector. Refer to Removal and Installation.
  2. Connect all of disconnected connectors.
  3. Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
Replace the electric shift control module. Refer to Removal and Installation.
INSPECTION END