[Previous][Next]
Driving Pattern
cautionAlways drive at a safe speed.
 
 
DRIVING PATTERN A
Driving pattern A means a trip satisfying the following conditions.
  • Engine speed reaches 400 rpm or more.
  • Engine coolant temperature rises by 20°C (36°F) or more after starting the engine.
  • Engine coolant temperature reaches 70°C (158°F) or more.
  • The ignition switch is turned from ON to OFF.
note
  • When the same malfunction is detected regardless of driving conditions, reset the counter of driving pattern A.
  • When the above conditions are satisfied without detecting the same malfunction, reset the counter of driving pattern A.
 
 
DRIVING PATTERN B
Driving pattern B means a trip satisfying the following conditions.
  • Engine speed reaches 400 rpm or more.
  • Engine coolant temperature reaches 70°C (158°F) or more.
  • Vehicle speed of 70 – 120 km/h (44 – 75 MPH) is maintained for 60 seconds or more under the control of closed loop.
  • Vehicle speed of 30 – 60 km/h (19 – 37 MPH) is maintained for 10 seconds or more under the control of closed loop.
  • Under the closed loop control condition, the following state reaches 12 seconds or more in total: Vehicle speed of 4 km/h (2 MPH) or less with idling condition.
  • The state of driving at 10 km/h (7 MPH) or more reaches 10 minutes or more in total.
  • A lapse of 22 minutes or more after engine start.
note
  • Drive the vehicle at a constant velocity.
  • When the same malfunction is detected regardless of driving conditions, reset the counter of driving pattern B.
  • When the above conditions are satisfied without detecting the same malfunction, reset the counter of driving pattern B.
 
 
DRIVING PATTERN C
Driving pattern C means operating vehicle as per the following:
The following conditions should be satisfied at the same time:
Engine speed: (Engine speed in the freeze frame data) ±375 rpm
Calculated load value: (Calculated load value in the freeze frame data) x (1±0.1) [%]
Engine coolant temperature condition:
  • When the freeze frame data shows lower than 70°C (158°F), engine coolant temperature should be lower than 70°C (158°F).
  • When the freeze frame data shows higher than or equal to 70°C (158°F), engine coolant temperature should be higher than or equal to 70°C (158°F).
note
  • When the same malfunction is detected regardless of the above vehicle conditions, reset the counter of driving pattern C.
  • When the above conditions are satisfied without detecting the same malfunction, reset the counter of driving pattern C.
  • The 1st trip DTC will be cleared when C counter is counted once without the same malfunction after DTC is stored in ECM.
 
 
DRIVING PATTERN D
Driving pattern D means a trip satisfying the following conditions.
  • The state of driving at 40 km/h (25 MPH) reaches 300 seconds or more in total.
  • Idle speed lasts 30 seconds or more.
  • A lapse of 600 seconds or more after engine start.
note
  • When the same malfunction is detected regardless of driving conditions, reset the counter of driving pattern D.
  • When the above conditions are satisfied without detecting the same malfunction, reset the counter of driving pattern D.