[Previous][Next]
Diagnosis Procedure
cautionPerform diagnosis under the condition that engine cannot start by the following procedure.
  1. Remove fuel pump fuse.
  2. Crank or start the engine (where possible) until the fuel pressure is released.
1.CHECK “S” TERMINAL CIRCUIT
  1. Ignition switch OFF.
  2. Disconnect starter motor connector.
  3. Shift selector lever to “P” or “N” position.
  4. Check voltage between starter motor harness connector and ground.
    (+)(–)ConditionVoltage
    Starter motor
    ConnectorTerminal
    F34SGroundWhen the ignition switch is in START position12V battery voltage
Is the inspection result normal?
“S” terminal circuit is OK. Further inspection is necessary. Refer to Work Flow.
.
 
2.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
  1. Ignition switch OFF.
  2. Disconnect IPDM E/R harness connector.
  3. Check continuity between starter motor harness connector and IPDM E/R harness connector.
    Starter motorIPDM E/RContinuity
    ConnectorTerminalConnectorTerminal
    F34SF4183Existed
  4. Check continuity between IPDM E/R harness connector and ground.
    IPDM E/RContinuity
    ConnectorTerminal
    F4183GroundNot existed
Is the inspection result normal?
Further inspection is necessary. Refer to Work Flow.
Repair harness.