Component Inspection (Camshaft position sensor)
1.
CHECK CAMSHAFT POSITION SENSOR-1
Turn ignition switch OFF.
Loosen the fixing bolt of the sensor.
Disconnect camshaft position sensor harness connector.
Remove the sensor.
Visually check the sensor for chipping.
Is the inspection result normal?
.
Replace camshaft position sensor.
2.
CHECK CAMSHAFT POSITION SENSOR-2
Check the resistance camshaft position sensor terminals as per the following.
Camshaft position sensor
Resistance [ Ω at 25°C (77°F)]
Terminals (Polarity)
1
2
Except 0 or ∞
3
2
3
Is the inspection result normal?
INSPECTION END
Replace camshaft position sensor. Refer to Removal and Installation
Exploded View
.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
.
Replace camshaft position sensor.INSPECTION ENDReplace camshaft position sensor. Refer to Removal and InstallationExploded View.