[Previous][Next]
Work Procedure
Before Replacing ECM
1.SAVE ECM DATA
With M.U.T.-III SE
  1. Turn ignition switch OFF.
  2. Reconnect all harness connectors disconnected.
  3. Turn ignition switch ON.
  4. Select "SAVING DATA FOR REPLC CPU" in "WORK SUPPORT" mode of "ENGINE" using M.U.T.-III SE.
  5. Follow the instruction of M.U.T.-III SE display.
note
  • Necessary data in ECM is copied and saved to M.U.T.-III SE.
  • Go to Step 2 regardless of with or without success in saving data.
: .
:
  • Replace ECM.
  • After replacing ECM, perform necessary work.
 
2.REPLACE ECM
Replace ECM. Refer to ECM : Removal & Installation.
: After replacing ECM, perform necessary work.
 
After Replacing ECM
1.PERFORM ECM PROGRAMMING
With M.U.T.-III SE
Perform ECM programming according to the procedure of "Programming" in M.U.T.-III SE Operation Manual. Refer to M.U.T.-III SE Operation Manual.
cautionDuring programming, maintain the following conditions:
  • Ignition switch: ON
  • Electric load: OFF
  • Brake pedal: Not depressed
  • Battery voltage: 12 – 13.5 V (Check the value displayed on the M.U.T.-III SE screen.)
: .
: .
 
2.PERFORM IGNITION SWITCH OPERATION
  1. Turn ignition switch OFF.
  2. Turn ignition switch ON.
: .
 
3.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS
Refer to Description.
: .
 
4.CHECK ECM DATA STATUS
Check if the data is successfully copied from the ECM at Step 1 (before replacement) and saved in M.U.T.-III SE.
Is the data saved successfully?
.
.
 
5.WRITE ECM DATA
With M.U.T.-III SE
  1. Select "WRITING DATA FOR REPLC CPU" in "WORK SUPPORT" mode of "ENGINE" using M.U.T.-III SE.
  2. Follow the instruction of M.U.T.-III SE display.
noteThe data saved by "SAVING DATA FOR REPLC CPU" is written to ECM.
: .
 
6.PERFORM VIN REGISTRATION
Refer to DescriptionDescription.
: .
 
7.WRITING MAC KEY FOR ECM
Refer to Description.
: .
 
8.PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING
Refer to DescriptionDescription.
: .
 
9.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
Refer to DescriptionDescription.
: .
 
10.PERFORM IDLE AIR VOLUME LEARNING
Refer to Description.
: .
 
11.PERFORM EGR VOLUME CONTROL VALVE CLOSED POSITION LEARNING
Refer to Description.
: .
 
12.CHECK DTC
  1. Turn ignition switch OFF and wait for 10 seconds or more.
  2. Turn ignition switch ON.
  3. If DTC is displayed, perform diagnosis of detected DTC. Refer to DTC Index.
: .
: END
 
13.WRITING MAC KEY FOR BCM
Refer to Description.
: END