[Previous][Next]
Work Procedure
1.START
With M.U.T.-III SE
  1. Start engine and warm it up to normal operating temperature.
  2. Select "SELF-LEARNING CONT" in "Learning" (in "Special Function") mode of "ENGINE" using M.U.T.-III SE.
  3. Clear mixture ratio self-learning value by touching "OK".
 
With GST
  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF.
  3. Disconnect mass air flow sensor harness connector.
  4. Restart engine and let it idle for at least 5 seconds.
  5. Stop engine and reconnect mass air flow sensor harness connector.
  6. Select Service $03 with GST. Make sure DTC P0102 is detected.
  7. Select Service $04 with GST to erase the DTC P0102.
 
: END