[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
When ECM cannot receive the engine communication signal from active grille shutter.
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detecting condition
U028400LOST COMM (A/GRLL SHTTR MDL A)
(Lost communication with active grille air shutter module A)
Diagnosis conditionIgnition switch ON
Signal (terminal)Engine communication signal
ThresholdECM cannot receive the engine communication signal from active grille shutter
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Harness and connectors (Engine communication line is open or circuit shorted.)
  • Active grille shutter
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.CHECK DTC PRIORITY
If DTC U0284 is displayed with another DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
Is applicable DTC detected?
Perform diagnosis of applicable. Refer to DTC Index.
.
 
2.PRECONDITIONING
If another DTC Confirmation Procedure is conducted just before this procedure, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 10 V or more with ignition switch ON.
: .
 
3.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON and wait at least 5 seconds.
  2. Check 1st trip DTC.
Is 1st trip DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END