[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P2B9600Injection pulse
(Injection Pulse Performance)
Diagnosis condition—
Signal—
ThresholdECM does not control fuel injection quantity properly when engine is running (except engine cold start).
Diagnosis delay time1 second
 
 
POSSIBLE CAUSE
ECM
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start engine and drive the vehicle as per the similar conditions to Freeze Frame Data for 5 seconds. Refer to the table below.
  2. Hold the accelerator pedal as steady as possible.
    cautionAlways drive vehicle in safe manner according to traffic conditions and obey all traffic laws when driving.
    • COOLANT TEMP
    • ENGINE SPEED
    • CAL/LD VALUE
Is DTC detected?
Proceed to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END