[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
noteIf DTC P2135 is displayed with DTC P06B0, first perform the trouble diagnosis for DTC P06B0. Refer to DTC Description.
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P213500TP SENSOR-B1
(Throttle/Pedal position sensor/switch “A” / “B” voltage correlation)
Diagnosis conditionEngine running at idle
Signal (terminal)TP sensor 1 signal and TP sensor 2 signal
ThresholdRationally incorrect voltage is sent to ECM compared with the signals from TP sensor 1 and TP sensor 2
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Harness or connector (TP sensor 1 or 2 circuit is open or shorted.)
  • Electric throttle control actuator (TP sensor 1 or 2)
 
 
FAIL-SAFE
Fail safe modeVehicle behavior
Device fix mode
  • This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position.
  • The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
  • A control signals is not transmitted to EGR volume control valve and the EGR volume control is deactivated.
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 8 V at idle.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start engine and let it idle for 1 second.
  2. Check DTC.
Is DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END