[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P211900ETC ACTR-B1
(Throttle Actuator "A" Control Throttle Body Range/Performance)
ADiagnosis condition
Signal (terminal)
ThresholdElectric throttle control actuator does not function properly due to the return spring malfunction
Diagnosis delay time
BDiagnosis condition
Signal (terminal)
ThresholdThrottle valve opening angle in fail-safe mode is not in specified range
Diagnosis delay time
CDiagnosis condition
Signal (terminal)
ThresholdECM detects that the throttle valve is stuck open
Diagnosis delay time
 
 
POSSIBLE CAUSE
Electric throttle control actuator
 
 
FAIL-SAFE
Engine operating condition in fail-safe mode
Fail safe modeVehicle behavior
Traveling control modeEngine output controlECM reduces the engine output, according to the rise in engine speed. This reduces the vehicle speed to encourage the driver to repair malfunction.
  • Driving at 70 km/h (44 MPH) or more is possible.
noteThis value is a reference value converted from engine power to vehicle speed. Actual power limitation value differs due to the malfunctioning part and driving condition.
Device fix mode
  • This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position.
  • The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
  • A control signals is not transmitted to EGR volume control valve and the EGR volume control is deactivated.
Electric throttle control cancel mode ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening (approx. 5 degrees) by the return spring.
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A AND B
  1. Turn ignition switch ON and wait at least 1 second.
  2. Set selector lever to D position and wait at least 3 seconds.
  3. Set selector lever to P position.
  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Turn ignition switch ON and wait at least 1 second.
  6. Set selector lever to D position and wait at least 3 seconds.
  7. Set selector lever to P position.
  8. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
  9. Check DTC.
Is DTC detected?
.
 
3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C
  1. Turn ignition switch ON and wait at least 1 second.
  2. Set selector lever to D position and wait at least 3 seconds.
  3. Set selector lever to P position.
  4. Start engine and let it idle for 3 seconds.
  5. Check DTC.
Is DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END