[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detecting condition
P157500BRAKE SW
(BRAKE SW)
Diagnosis condition
Signal (terminal)CAN communication signal
ThresholdStop light switch signal is sent to ECM for extremely long time while the vehicle is being driven.
Diagnosis delay time
 
 
POSSIBLE CAUSE
Stop light switch (BCM)
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
: .
 
2.COMPONENT FUNCTION CHECK
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Select “DATA MONITOR” mode of “ENGINE” with M.U.T.-III SE.
  3. Check that the “BRAKE SW” indication as per the following condition.
    Monitor itemConditionIndication
    BRAKE SWBrake pedalFully releasedOFF
    Slightly depressedON
 
Without M.U.T.-III SE
  1. Turn ignition switch OFF.
  2. Check the stop light when depressing and releasing the brake pedal.
    Brake pedalStop light
    Fully releasedNot illuminated
    Slightly depressedIlluminated
 
Is the inspection result normal?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END
-2Refer to DTC Diagnosis Procedure.