[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P122600CTP LEARNING-B1
(CTP LEARNING-B1)
Diagnosis conditionIgnition switch ON
Signal (terminal)Electric throttle control actuator signal
ThresholdClosed throttle position learning is not performed successfully, repeatedly
Diagnosis delay time
 
 
POSSIBLE CAUSE
Electric throttle control actuator (TP sensor 1 and 2)
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF, wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Repeat steps 2 and 3 for 32 times.
  5. Check 1st trip DTC.
Is 1st trip DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END