[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P060600CONTROL MODULE
(Control module processor)
Diagnosis condition
Signal (terminal)
ThresholdMalfunction in ECM processor
Diagnosis delay time
 
 
POSSIBLE CAUSE
ECM
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE-I
  1. Turn ignition switch ON (engine stopped) and wait at least 10 seconds.
    cautionNever start engine during this procedure.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Check 1st trip DTC.
Is 1st trip DTC detected?
.
 
3.PERFORM DTC CONFIRMATION PROCEDURE-II
  1. Start engine.
  2. Rev up the engine quickly to approximately 3,000 rpm under unloaded condition and completely release the accelerator pedal.
  3. Let the engine idle and wait at least 10 seconds.
  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Turn ignition switch ON.
  6. Check 1st trip DTC.
Is 1st trip DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END