[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P052000EOP SENSOR/SWITCH
(Engine oil pressure sensor/switch A circuit)
Diagnosis conditionEngine running at idle
Signal (terminal)Engine oil pressure sensor signal
Threshold
  • A voltage signal transmitted from the engine oil pressure sensor is lower than 0.3 V
  • A voltage signal transmitted from the engine oil pressure sensor is higher than 5.02 V
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Harness or connectors
    • EOP sensor circuit is open or shorted.
    • Sensor power supply 2 circuit is shorted.
  • EOP sensor
  • Each sensor, connected with sensor power supply 2 circuit
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON and wait at least 5 seconds.
  2. Check 1st trip DTC.
Is 1st trip DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END