[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P044B00EGR SENSOR C
(EGR Sensor "C" Circuit Range/Performance)
Diagnosis conditionAfter warming up, switch OFF the ignition every time the engine is stopped.
Signal (terminal)
ThresholdWhen EGR volume control valve is fully closed or fully opened, sensor output is out of the specified range.
Diagnosis delay time3 seonds or more
 
 
POSSIBLE CAUSE
EGR volume control valve failure (sensor failure, internal gear damage, valve movement is not smooth)
 
 
FAIL-SAFE
Engine operating condition in fail-safe mode
Fail safe modeVehicle behavior
Traveling control modeAccelerator angle variation controlECM controls the accelerator pedal depression speed to make it slower than actual speed. This causes a drop in accelerating performance and encourages the driver to repair malfunction.
noteECM does not control the accelerator pedal releasing speed.
Device fix mode
  • This mode fixes the electric IVT motor and the EVT control solenoid valve in the reference position.
  • The intake manifold runner control valve motor is turned OFF (intake manifold runner control valve opens).
  • A control signals is not transmitted to EGR volume control valve and the EGR volume control is deactivated.
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine and warm it up to normal operating temperature.
  2. Stop the engine.
  3. Switch ON the ignition and wait at least 3 seconds.
Is the DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END