[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P019700EOT SEN/CIRK
(Engine oil temperature sensor A circuit low)
Diagnosis conditionEngine running at idle
Signal (terminal)Engine oil temperature sensor signal
ThresholdAn excessively low voltage from the sensor is sent to ECM
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Harness or connectors (The EOT sensor circuit is open or shorted.)
  • Engine oil temperature sensor
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start engine and wait at least 5 seconds.
  2. Check 1st trip DTC.
Is 1st trip DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END