[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P010700ABSL PRES SEN/CIRC
(Atmospheric pressure sensor circuit low input)
Diagnosis conditionEngine running at idle
Signal (terminal)
ThresholdAn excessively low voltage from the atmospheric pressure sensor (built-into ECM) is sent to ECM
Diagnosis delay time
 
 
POSSIBLE CAUSE
Atmospheric pressure sensor (built-into ECM)
 
 
FAIL-SAFE
Not applicable
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 60 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 60 seconds.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start engine and let it idle for 5 seconds.
  2. Check 1st trip DTC.
Is DTC P0107 detected?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END