[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P010600ABSL PRES SEN/CIRC
(Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance)
Diagnosis condition
Signal (terminal)MAP sensor signal
Threshold
  • Difference between intake manifold pressure and estimated intake manifold pressure while steady driving condition.
  • An excessively low voltage from the sensor is sent to ECM.
  • An excessively high voltage from the sensor is sent to ECM.
Diagnosis delay time5 consecutive seconds
 
 
POSSIBLE CAUSE
  • Harness or connectors
  • MAP sensor
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 1 minute before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Accelerate the vehicle from 40 km/h (25MPH) to 70 km/h (44 MPH) or more within 7 seconds.
    cautionAlways drive vehicle in safe manner according to traffic conditions and obey all traffic laws.
    noteKeeping the accelerator pedal as steady as possible at approximately 3/8 during the acceleration allows easy diagnosis.
  2. Check DTC.
Is DTC detected?
Proceed to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END