[Previous][Next]
Diagnosis Procedure
1.CHECK LIN COMMUNICATION CIRCUIT
  1. Turn ignition switch OFF.
  2. Disconnect ECM harness connector and generator harness connector.
  3. Check the continuity between ECM harness connector and generator harness connector.
    ECMGeneratorContinuity
    ConnectorTerminalConnectorTerminal
    F5121F312Existed
  4. Also check harness for short to power and short to ground.
Is the inspection result normal?
.
Repair or replace error-detected parts.
 
2.REPLACE GENERATOR
  1. Replace generator. Refer to Removal and Installation.
  2. Erase DTC.
  3. Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC detected again?
Replace ECM. Refer to Removal & InstallationECM : Removal & Installation.
INSPECTION END