[Previous][Next]
Component Inspection
1.CHECK INTAKE AIR TEMPERATURE SENSOR
  1. Turn ignition switch OFF.
  2. Disconnect mass air flow sensor harness connector and reconnect it again.
  3. Turn ignition switch ON.
  4. Select "DATA MONITOR" mode with M.U.T.-III SE.
  5. Check that "INT/A TEMP SE" indicates as per following condition.
    Monitor itemCondition ValueValues
    INT/A TEMP SETemperature [°C (°F)]25 (77)20 - 30°C (68 - 86°F)
    80 (176)75 - 85°C (167 - 185°F)
Is the inspection result normal?
INSPECTION END
Replace mass air flow sensor (with intake air temperature sensor). Refer to Exploded View.