[Previous][Next]
Component Inspection
1.CHECK ASCD STEERING SWITCH
  1. Disconnect combination switch (spiral cable) harness connector.
  2. Check the resistance between combination switch harness connector terminals as per the following conditions.
    Combination switch
    (Spiral cable)
    ConditionResistance
    (Approx.)
    Connector+
    Terminals
    M1542136MAIN switch: Pressed0 Ω
    CANCEL switch: Pressed250 Ω
    SET− switch: Pressed660 Ω
    RES+ switch: Pressed1,480 Ω
    All ASCD steering switches: Released4,000 Ω
Is the inspection result normal?
INSPECTION END
Replace ASCD steering switch. Refer to Component Parts Location.