[Previous][Next]
Component Function Check
1.PERFORM COMPONENT FUNCTION CHECK
With GST
  1. Start engine and warm it up to normal operating temperature.
  2. Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position.
  3. Shift the selector lever to the D position, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (31 MPH).
    cautionAlways drive vehicle at a safe speed.
    noteNever apply brake during releasing the accelerator pedal.
  4. Repeat steps 2 to 3 for five times.
  5. Stop the vehicle and turn ignition switch OFF.
  6. Wait at least 10 seconds and restart engine.
  7. Repeat steps 2 to 3 for five times.
  8. Stop the vehicle.
  9. Check 1st trip DTC.
Is 1st trip DTC detected?
Proceed to Refer to DTC Diagnosis Procedure.
INSPECTION END