[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove engine under cover. Refer to Removal and Installation.
2. Drain engine coolant from radiator. Refer to Draining.
cautionPerform this step when the engine is cold.
3. Remove drive belts. Refer to Removal and Installation.
4. Remove water pump.
  • Engine coolant leakage from cylinder block, so have a receptacle ready below.
caution
  • Handle water pump vane so that it does not contact any other parts.
  • Water pump cannot be disassembled and should be replaced as a unit.
 
 
INSTALLATION
Installation is in the reverse order of removal.
cautionDo not reuse water pump gasket.
  • Tighten water pump bolts to the specified torque in the sequence shown.
    Bolts :25 N·m (2.6 kg-m, 18 ft-lb)
  • Refill the cooling system. Refer toRefilling .