LIFTING, JACKING SUPPORT LOCATION
GARAGE JACK
caution | - Be sure to support the specified locations only. Otherwise, deformation of vehicle may occur.
- Be careful to avoid damage to the front under cover or rear differential carrier assembly.
|
RIGID RACKS AND A SINGLE-POST LIFT OR DOUBLE-POST LIFT
caution | - If rubber attachments with grooves that are too thick are used at the front support positions, the
front fender may become bent, so be sure to use rubber attachments with groove thicknesses of
18 mm (0.7 inch) or less.
- If attachments which are not high enough are used, they may damage areas such as the side step.
Be sure to use attachments which are high enough, or remove the side step if not using attachments.
|
PLATE TYPE LIFT
caution | - Be sure to support the specified locations only. Otherwise, deformation of vehicle may occur.
- Be careful to avoid damage to the side sill garnish.
Support the notch with a spacer [100-mm (3.9-inch)
width, 100-mm (3.9-inch) height and 200-mm
(7.9-inch) depth]. |