[Previous][Next]
Work Procedure
warningBe careful of traffic conditions and safety around the vehicle when performing road test.
caution
  • Fully understand the following items well before the road test;
1.CHECK RCTA SYSTEM SETTING
  1. Start the engine.
  2. After start the engine wait for 30 seconds or more.
  3. Enable the setting of the RCTA system on the information display.
  4. Turn OFF the ignition switch and wait for 5 seconds or more.
  5. Check that the previous setting is saved when the engine starts again.
: .
 
2.ACTION TEST FOR RCTA
  1. Enable the setting of the RCTA system on the information display.
  2. Check the RCTA operation according to the following table.
    ConditionActionIndication on the BSW indicatorDisplay on information displayBuzzer
    RCTA OFF—OFF—OFF
    RCTA ONShift lever is in any position other than reverse—OFF—OFF
    Shift lever is in reverse Vehicle speed is less then approx. 8 km/h (5 MPH) Vehicle is not detected—OFF—OFF
    Vehicle is detected—Blink—ON
    Vehicle speed is approx. 8 km/h (5 MPH) or moreVehicle is detected————
: INSPECTION END