[Previous][Next]
Work Procedure
warningBe careful of traffic conditions and safety around the vehicle when performing road test.
caution
  • Fully understand the following items well before the road test;
1.CHECK TSR SYSTEM SETTING
  1. Start the engine.
  2. After starting the engine wait for 30 seconds or more.
  3. Enable the setting of the TSR system on the information display.
  4. Turn OFF the ignition switch and wait for 5 seconds or more.
  5. Check that the previous setting is saved when the engine starts again.
: .
 
2.ACTION TEST FOR TSR
  1. Enable the setting of the TSR system on the information display.
  2. Check the TSR operation according to the following table.
    7 inch Information Display
    System statusConditionDisplay on information display
    TSR OFF——
    TSR ONRoad sign not detected—
    Road sign detected (except for speed limit signs)This is an example. For details of displayed signs, Refer to System Description.
    Road sign detected (Speed limit signs)This is an example. For details of displayed signs, Refer to System Description.
    FULL TFT METER
    System statusConditionDisplay on information displayDisplay on Head Up Display
    TSR OFF———
    TSR ONRoad sign not detected——
    Road sign detected (except for speed limit signs)This is an example. For details of displayed signs, Refer to System Description.
    		This is an example. For details of displayed signs, Refer to System Description.
    Road sign detected (Speed limit signs)This is an example. For details of displayed signs, Refer to System Description.
    		This is an example. For details of displayed signs, Refer to System Description.
: INSPECTION END