Work Procedure
Vehicle specification needs to be written with M.U.T.-III SE because it is not written after replacing the ADAS control unit 2.
The configuration requires network connection. M.U.T.-III SE connects to network and then it downloads the configuration data from the server. Then M.U.T.-III SE writes the vehicle specification to the ADAS control unit 2.
| note | For details the network connection and operation, refer to “M.U.T.-III SE Operation Manual”. The configuration no need to “save” configuration data from the ADAS control unit 2. The configuration data is always generated freshly at the server and then downloaded to the M.U.T.-III SE. |
| caution | - Complete the procedure of “Configuration” in order.
- If incorrect “Configuration”, incidents might occur.
|
1.WRITING VEHICLE SPECIFICATION
With M.U.T.-III SEPerform writing vehicle specification to ADAS control unit 2 following "Automatic Configuration" procedure of "Configuration" according to M.U.T.-III SE Operation Manual.
| note | - Log in the network according to M.U.T.-III SE guidance.
- For details the network connection and operation, refer to “M.U.T.-III SE Operation Manual”.
|
: WORK END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)