DTC Diagnosis Procedure
1.
CHECK CONNECTOR
Turn the ignition switch OFF.
Check the terminals and connectors of the side radar LH/RH for damage, bend and short (unit side and connector side).
Is the inspection result normal?
.
Repair the terminal or connector.
2.
CHECK CONTINUITY OF RIGHT/LEFT SWITCHING SIGNAL CIRCUIT
Disconnect side radar LH/RH connector.
Check continuity between side radar LH/RH harness connector and ground.
Side radar LH
Ground
Continuity
Connector
Terminal
B461
11
Yes
Side radar RH
Ground
Continuity
Connector
Terminal
B462
5
Yes
11
Is the inspection result normal?
Inspection End.
Repair harness or connector.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
.
Repair the terminal or connector.Inspection End.Repair harness or connector.