[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1E92-17Power supply circuit
(Power supply circuit)
Diagnosis condition When engine is running
Signal (terminal) Battery power supply
Threshold The battery voltage sent to side radar RH remains more than 19.3 V
Diagnosis delay time 5 seconds or more
 
 
POSSIBLE CAUSE
  • Connector, harness, fuse
  • Side radar RH
 
 
FAIL-SAFE
The following systems are canceled.
  • BSW
  • Active Blind Spot Assist [ABSA]
  • RCTA
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “C1E92-17” is detected as the current malfunction in “Self Diagnostic Result” of “Side radar (Rear right)”.
Is “C1E92-17” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure .
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END