[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1E81-12 Incorrect installation location
(Incorrect installation location)
Diagnosis condition When Ignition switch is ON.
Signal (terminal) –
Threshold Short circuit in BSW indicator circuit is detected. (Over current is detected)
Diagnosis delay time –
 
 
POSSIBLE CAUSE
  • BSW indicator circuit
  • BSW indicator
  • Side radar
 
 
FAIL-SAFE
The following systems are canceled.
  • BSW
  • Active Blind Spot Assist [ABSA]
  • RCTA
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “C1E81-12” is detected as the current malfunction in “Self Diagnostic Result” of “Side radar (Rear right)”.
Is the “C1E81-12” detected as the current malfunction?
DTC Diagnosis ProcedureDiagnosis Procedure
-1 To check malfunction symptom before repair: Intermittent IncidentIntermittent Incident
-2 Confirmation after repair: INSPECTION END