[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1E00–46 Control unit
(Control unit)
Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold If side radar left is malfunctioning
Diagnosis delay time 5 seconds or more
 
 
POSSIBLE CAUSE
Side radar LH
 
 
FAIL-SAFE
The following systems are canceled.
  • BSW
  • Active Blind Spot Assist [ABSA]
  • RCTA
 
 
CONFIRMATION PROCEDURE
1.CHECK DTC PRIORITY
If DTC “C1E00–46” is displayed with Network-DTC, first diagnose the Network-DTC.
Is applicable DTC detected?
Perform diagnosis of applicable. Refer to DTC IndexDTC Index .
.
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “C1E00–46” is detected as the current malfunction in “Self Diagnostic Result” of “Side radar (Rear left)”.
Is the “C1E00–46” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure .
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END