[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2E4B–06Remote actuator without cipher key
(Remote actuator without cipher key)
Diagnosis conditionWhen receiving remote command
Signal (terminal)—
ThresholdCommunication error
Diagnosis delay time—
 
 
POSSIBLE CAUSE
Communication error due to improper TCU.
 
 
FAIL-SAFE
Remote function does not operate
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 30 seconds.
  3. Turn ignition switch ON and wait at least 30 seconds or more.
  4. Operate the remote function of the telematics system.
  5. Select “Self Diagnostic Result” mode of “IVC” using M.U.T.-III SE.
  6. Check DTC.
Is DTC B2E4B–06 detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END