[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2A0C–86TCM
(TCM)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)CAN communication signal
ThresholdCannot receive shift position signal from TCM
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
  • TCM
  • Around view monitor control unit
 
 
FAIL-SAFE
  • Front camera image and rear camera image are not displayed (black screen display)
  • Rear view is not displayed even if the shift position is reversed
  • MOD (Moving Object Detection) function is cancel
 
 
DTC CONFIRMATION PROCEDURE
1.CHECK DTC PRIORITY
If DTC B2A0C–86 is displayed with DTC U2141-87, first perform the confirmation procedure (trouble diagnosis) for DTC U2141-87.
Is applicable DTC detected?
Perform diagnosis of applicable. Refer to DTC Description.
.
 
2.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn the ignition switch ON.
  2. Perform “Read All DTCs” with M.U.T.-III SE.
  3. Check if the “B2A0C–86” is detected as the current malfunction in “Self Diagnostic Result” of “Multi Around Monitor”.
Is “B2A0C–86” detected as the current malfunction?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END