[Previous][Next]
Diagnosis Procedure
1.PERFORM DTC CONFIRMATION PROCEDURE (1)
With M.U.T.-III SE
  1. Remove the USB device connected to the front auxiliary input jack.
  2. Turn ignition switch OFF and wait at least 4 minute or more.
  3. Turn ignition switch ON and wait at least 1 minute or more.
  4. Erase DTC.
  5. Turn ignition switch OFF and wait at least 4 minute or more.
  6. Turn ignition switch ON and wait at least 1 minute or more.
  7. Select “Self Diagnostic Result” mode of “MULTI AV” using M.U.T.-III SE.
  8. Check DTC.
Is DTC B13D9–8F detected?
Replace front auxiliary input jack. Refer to Removal and Installation.
.
 
2.PERFORM DTC CONFIRMATION PROCEDURE (2)
With M.U.T.-III SE
  1. Connect a USB device to the front auxiliary input jack.
  2. Turn ignition switch OFF and wait at least 4 minute or more.
  3. Turn ignition switch ON and wait at least 1 minute or more.
  4. Erase DTC.
  5. Turn ignition switch OFF and wait at least 4 minute or more.
  6. Turn ignition switch ON and wait at least 1 minute or more.
  7. Select “Self Diagnostic Result” mode of “MULTI AV” using M.U.T.-III SE.
  8. Check DTC.
Is DTC B13D9–8F detected?
An error in the USB device connected to the front auxiliary input jack.
INSPECTION END