Electric Shift Warning Light
DESIGN/PURPOSE
The electric shift warning light illuminates when a malfunction occursin the electric shift control system.
BULB CHECK
For 2 seconds after the ignition switch is turned ON.
SYNCHRONIZATION WITH MASTER WARNING LIGHT
Not applicable
OPERATION AT COMBINATION METER CAN COMMUNICATION CUT-OFF OR UNUSUAL SIGNAL
For actions on CAN communications blackout in the combination meter, refer to
Fail-Safe
.
SIGNAL PATH
- The electric shift control module transmits an electric shift malfunction signal to the TCM when detecting malfunction in the electric shift system.
- The TCM detects DTC when TCM receives an electric shift malfunction signal.
- The TCM transmits an electric shift malfunction signal, a shift position signal, and a neutral hold mode signal to the combination meter when detecting DTC in TCM.
- The ABS actuator and electric unit (control unit) transmits an electric parking brake status signal to the combination meter.
- The combination meter turns ON the electric shift warning light according to each signal. Refer to
LIGHTING CONDITION
When any of the following conditions are satisfied.
- Except neutral hold mode
- Shift position is except P position
- Electric shift system malfunction (Transmission does not shift to P position due to electric shift system malfunction)
- Vehicle speed is less than 5 km/h(3 MPH)
- Parking brake is not applied
SHUTOFF CONDITION
When any of the conditions listed below is satisfied:
- In neutral hold mode
- Shift position is P position
- Electric shift system is normal
- Vehicle speed is 5 km/h (3 MPH) or more
- Parking brake is applied
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)