[Previous][Next]
Diagnosis Procedure
1.CHECK CONNECTOR
  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the around view monitor control unit for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?
.
Repair the terminal and connector.
 
2.CHECK HARNESS FOR OPEN CIRCUIT
  1. Disconnect the connector of around view monitor control unit.
  2. Check the resistance between the around view monitor control unit harness connector terminals.
    Around view monitor control unit harness connectorResistance (Ω)
    Connector No.Terminal No.
    B75320Approx. 54 – 66
Is the measurement value within the specification?
.
Repair the around view monitor control unit branch line.
 
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the around view monitor control unit. Refer to Diagnosis Procedure.
Is the inspection result normal?
(Present error)Replace the around view monitor control unit. Refer to Removal and Installation.
(Past error)Error was detected in the around view monitor control unit branch line.
Repair the power supply and the ground circuit.