Removal and Installation
REMOVAL
1.
Remove steering angle sensor. Refer to
Removal and Installation
.
2.
Disconnect harness connector from combination switch.
3.
Remove the combination switch
mounting screw
.
4.
Pull out the combination switch
by moving it alternately on the right and left side.
caution
Never deformation and damage the pawls.
: Pawl
INSTALLATION
Install in the reverse order of removal.
caution
Never reuse combination switch. Always replace it with a new one when it is removed.
Visually check the pawls for deformation and damage during installation. Replace with new ones if necessary.
Insert the combination switch so that the protrusion
of the combination switch
and the cut-out
of the steering column
match together.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
.
mounting screw 
.)
by moving it alternately on the right and left side.)
of the steering column 
match together.)