[Previous][Next]
Removal and Installation
cautionDisconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
 
 
REMOVAL
 
 
1. Disengage license plate light fixing pawl according to numerical order 1→2 indicated by arrows as shown in the figure.
2. Disconnect license plate light harness connector, and then remove license plate light.
 
 
INSTALLATION
 
 
1. Connect license plate light harness connector.
2. Put license plate light in the hole without fixing pawl and hook by as shown in the figure.
3. Push the license plate light hook side and pull out the license plate light fixing pawl side by as shown in the figure.
4. Push license plate light to the position where hook falls.
5. Engage license plate light fixing pawl , and then install license plate light.