[Previous][Next]
Diagnosis Procedure
 
 
1.CHECK FUSE
  1. Ignition switch OFF, and then wait for 3 minutes with driver door open.
    note
    • Even after ignition switch is OFF, power is supplied to accessories for a certain amount of timer by the AUTO ACC function.
    • When vehicle is operate while on standby, power may be supplied to accessories.
  2. Check that the following fuse is not blown (open).
    Fuse No.Current rating
    455 A
Is the fuse blown (open)?
Repair the blown (open) fuse after repairing the affected circuit if a fuse is blown (open).
 
2.CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY
  1. Disconnect power window main switch connector.
  2. Ignition switch ON.
  3. Check voltage between power window main switch harness connector and ground.
    (+)(–)Voltage
    Power window main switch
    ConnectorTerminal
    D6*1
    D27*2
    		3Ground9 – 16 V
    *1 : With automatic drive positioner
    *2 : Without automatic drive positioner
Is the inspection result normal?
Repair or replace harness.
 
3.CHECK POWER WINDOW MAIN SWITCH GROUND CIRCUIT
  1. Ignition switch OFF.
  2. Check continuity between power window main switch harness connector and ground.
    Power window main switch—Continuity
    ConnectorTerminal
    D6*1
    D27*2
    		22GroundExisted
    *1 : With automatic drive positioner
    *2 : Without automatic drive positioner
Is the inspection result normal?
INSPECTION END
Repair or replace harness.